AJAX MotionCam Outdoor (PhOD) sensor wireless PIR detector white security external alarm

Wireless outdoor motion detector with a photo camera for alarm verification.

MotionCam Outdoor detects intrusion from the very first steps into the area and confirms it with a series of animated photos. Visual verification helps to immediately clarify the situation, saving users from worries and security companies from unnecessary patrol dispatch.

By combining the best optics, a fast processor, and advanced software algorithms, MotionCam Outdoor captures informative images in any weather conditions, day or night.

MotionCam Outdoor is equipped with two independent PIR sensors, whose signals are analyzed with a two-step LISA algorithm. When both sensors detect motion, LISA performs correlation and spectral signal analysis, helping to immediately distinguish real threats from disturbances.

Whenever MotionCam Outdoor detects motion, LISA analyzes and compares the signal forms of the two sensors in real-time. If the forms are similar, the alarm is triggered.

MotionCam Outdoor cannot be discreetly disabled, even if the system is turned off. The detector is equipped with masking sensors that respond to lens blocking, covering, and painting.

The hub will need less than a minute1 to detect a communication loss with the detector and inform the central monitoring station and users about the problem. It will become known immediately if MotionCam Outdoor has been dismantled.

MotionCam Outdoor withstands heat up to +60°C and cold down to −25°C. To protect the anti-masking system’s sensors from rain and snow, we included a special hood.

MotionCam Outdoor simultaneously uses two secure radio protocols: Jeweller and Wings. The radio protocols operate independently of each other, each focused on its function. Jeweller transmits the alarm signal in 0.15 seconds, and thanks to Wings, the first shot from the site will appear in the app in less than 9 seconds.
The radio wave range is sufficient to install the detector where it will be most effective. Battery life up to 3 years reduces maintenance work.
The process of connecting and configuring MotionCam Outdoor saves installation engineers’ time in the best possible way. To add the detector to the system, simply scan the QR code with the Ajax app, assign it a name and room. Configure the device in real-time in the app, check detection zones and communication. If necessary, the detector can be disabled or its system parameters can be reconfigured remotely, without visiting the site.